Assembling rear spar - 9 April 2009

6.0 hours

	Priming rear spar parts(Full size) I didn't take pictures of the inboard parts drilling. They can be seen in later pictures during the riveting. Here all the parts have been cleaned, and primed
	Inboard end of rear spar(Full size) Cleco'd the W-907C, W-907B doublers to the W-907A spar
	Rivets installed in spar(Full size) Here is the finished rivets. Took quite a while to make sure I didn't have rivets installed where they shouldn't be (yet).
	W-907D riveted(Full size) Not many rivets go in this one now
	W-907E riveted(Full size) Here are the rivets in the W-907E doubler. I dimpled both the doubler and the spar for the outboard rivet holes. Since they are .040 thick dimpling is ok.